LM Cases

This case was built for dmr-rents.com. The case is designed around a Pelican 1450 waterproof case. The U5 is cradled in a custom cut foam insert that accommodates the ground lift switch in the back of the unit as well as front controls. The front of the unit is supported with a pice of foam [...]

This case was built for the Morale Welfare & Recreation division of the Navy. The case is designed to hold 1 ton and 2 ton CM Lodestar motors. The motors are held in interchangeable birch cradles. The cradles contour the exact shape of the motors allowing for safe transportation. New cradles to hold 1/2 ton [...]

This case was designed for the Audio Visual Professional Group. The case is from our XL Series (Click Here For Info). XL Series cases are designed for light weight portable applications, they work especially well in the rental markets. The case features a 1″ foam lined interior with strategic blocking at the faders and around [...]

This case is designed for the Presonus Studiolive 16.0.2 mixer. The case is built out of 1/4″ plywood to keep it lightweight and manageable. The case interior features a 1″ foam lined interior with strategic foam blocking to keep the mixer in place during transportation. There is a foam slot under the mixer for cable [...]

This sideline trunk is a must have for any team! The trunk is built out of a 3/8″ plastic honeycomb panel that allows the case to be extremely light (just under 90lbs) and water resistant. The case is built around the standard 90″ quarter truck pack with outside dimensions of 45″ left to right by [...]

This case was designed for Smart Technologies. The case is designed to transport the PA system used for trade shows around the world in the most demanding transportation situations. The case is also designed to be easy to move by incorporating over a years worth of ergonomic research by the LM Cases design department. This [...]

This case was designed for a Presonus Studiolive 24. The case features a 1″ foam lined interior and a custom 3/4″ Birch doghouse that contours the back of the board. The exterior case is made out of 1/4″ plywood and features 5 recessed handles.

This case was designed for the Audio Visual Professional Group. The case holds a Line 6 XD-V70 wireless mic system in a custom CNC cut foam insert. The insert holds the microphone in its factory case as well as the receiver, antennas, power supply & cables. The exterior case is our light duty XL Series, [...]

This case was designed for Visual Aids Electronics. The design is based around a Pelican 1550 case, the case features a custom CNC cut foam insert to hold the wireless system. Each component of the system is held in a custom foam lined compartment. This allows both VAE and their customers to realize if a [...]

This case was designed for KM Productions NY. The case features a removable front and top lid, allowing easy access to the front of the console during a show. The bottom tray features a 2 rack space section for a drawer and or keyboard shelf. The interior case also features a custom 3/4″ Birch doghouse [...]